Thermostat
You are here: Home » Thermostat
Product Detail
Share to:

TM26 Cheap and easy to use for thermostat

Color:White Size:86mm*86mm Material:PC Sales Models:Wholesale Min order:10pcs

  • TM26
  • We can OEM
    • 06
    • 16
    • 26
  • AC230V(AC110V/AC24V available)
  • 5W
  • 5℃~40℃
  • ±0.5K
  • -5℃~50℃
  • IP20
  • anti-flammable PC
  • rubber-thermoplastic NTC sensor, cable length 3m
TM26 electronic heatingthermoatet
This type  electronic thermostat  for  mounting in standard wall box, the thermostat isadjustable to required temperature from +5/+40C, the LED shows that the heal is On. the thermostat is recommended for control of electric heating devices or on/off valve actuator u sed
in water-based heating systems

Technlcal data:
Voltage : AC230V(AC 110V /AC24V available)
Power  consumption  : SW
Setting  range :  PL'--40‘L'
Switching  differential : 0 5K
Ambient  temperature :  -5“L"--50‘
Protective  housing  : lP20
Housing  material  : anti-flammable  PC
Floor sensor  : rubber-thermoplastic   NTC sensor, cable  length  is 3m

Mounting of Floor Sensor
Floor sensor shou Id be placed in installation pipe wh ich is embed- ded in floor, the pipe is th ic kened in the end and placed as h igh a s possib Ie in the concrete layer. Se n so r ca b Ie may be e xte nded up to 50 m with sepa rate cable for power curren t. Two co nductors in a multi-conducting cable, wh ich e. g. is used for supp ly of heating cable, may not be used  Voltag e signa Is, whic h may disturb Ih e
function of the thermostat,  may occur.  If the cable is used with  screer ,
th e screen may not be cDn nected to the ground, b ut inust be conncctcd to tcrm inal, the best installation is attained w ilh a
separate cablu for the sensor, which is then inounted in a sep a rate conduit.

Thermostat Adjustment
Wh an the roqm temperature has been stabilized, the thermos- tat set position may be adjusted ta match a ctual room tempera- tu re. Mea sure the temperature of the room with an a ecu rate
the rmometer. Remove control knab(1) and spin the pole(D), then reposition the o3n tro I knob so that the indicaled tempera- tu re line shows the same as the measured temperature (picture 2). We have adjusted the temperature, please do not sp in the pole when installation.

Max./Min. Tern perature Settin g
A locking mechanism is positioned behind the control knob to limit the a mount of a djustment possible. By loosening the little screw C (p icture2)the sea Ie range can be locked , e.g. Between 20'C and 25"?. The red ring indicates the maximum tempe ra- ture an d the g reen ring indicate s the minimum tern perature.